Differences

This shows you the differences between two versions of the page.

--- iot2040setup [2020/05/12 19:35]
wikiadmin
+++ iot2040setup [2020/05/12 19:35] (current)
wikiadmin
@@ Line 1: / Line 1: @@
 . Create a SD flash card with the Example Image from https://support.industry.siemens.com/cs/document/109741799/simatic-iot2000-sd-card-example-image?dti=0&lc=en-WW, such as https://support.industry.siemens.com/cs/attachments/109741799/Example_Image_V2.2.0.zip
-e.g. on Linux, new flash is mounted on /dev/sdd, open teminal in the directory where the example image "example_image.wic" resides, use <code bash>sudo dd if=example_image.wic of=/dev/sdd bs=4M</code>, then use <code bash>sync</code> and wait until the flash is completely written
+e.g. on Linux, new flash is mounted on /dev/sdd, open teminal in the directory where the example image "example_image.wic" resides, use <code bash>sudo dd if=example_image.wic of=/dev/sdd bs=4M</code>then use <code bash>sync</code> and wait until the flash is completely written
 . Insert new flash card into IOT2040, insert Ethernet cable into X1P1LAN, power on the system, and wait for boot up. Ethernet will be active when fully booted.