Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
secstester_getsvidvalue [2020/05/12 19:26] wikiadmin |
secstester_getsvidvalue [2020/05/12 19:29] (current) wikiadmin |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| - Start the SECS Tester | - Start the SECS Tester | ||
| - Double-Click on "Set Up Communications to Tool" to open the Communications Setup Dialog | - Double-Click on "Set Up Communications to Tool" to open the Communications Setup Dialog | ||
| - | - The default tool configuration will be shown. You can change the tool name so that this configuration will be saved as a new tool setup. | + | - The default tool configuration will be shown. You can change the tool name so that this configuration will be saved as a new tool setup. |
| - | | + | |
| - | | + | |
| - | | + | |
| - | | + | |
| - Select the new tool configuration from the combo box. You should see the tool configuration printed out in the text field on the right. | - Select the new tool configuration from the combo box. You should see the tool configuration printed out in the text field on the right. | ||
| - | | + | - Connect to the tool |
| - | * | + | - Press " |
| - | * If the communications was successful you will see a response from the tool. | + | - If the communications was successful you will see a response from the tool. |
| - | * # Go online-remote with the tool | + | |
| - | * | + | - Be sure the tool is ready to go online with this host and is allowing remote communications. |
| - | * Press " | + | - Press " |
| - | * | + | - If the online request was successful you will see an S1F18 response with a reply other than " |
| - Once the tool is ONLINE-REMOTE you can get a list of SVIDs and request the current value of any of them. | - Once the tool is ONLINE-REMOTE you can get a list of SVIDs and request the current value of any of them. | ||
| - | | + | |
| - | * Click on the "Get List of SVIDs" button to send an S1F11 to the tool | + | - Click on the "Get List of SVIDs" button to send an S1F11 to the tool |
| - | * If the tool has SVIDs, these VIDs will show up in the SVID List combo box, alphabetically by SVID name | + | - If the tool has SVIDs, these VIDs will show up in the SVID List combo box, alphabetically by SVID name |
| - | * Select an SVID and press the "Get Current Value" to send an S1F3 to the tool | + | - Select an SVID and press the "Get Current Value" to send an S1F3 to the tool |
| - | * The current value will be displayed below the "Get Current Value" button | + | - The current value will be displayed below the "Get Current Value" button |